by Bob Lazar The S4 “Sport Model” Flying DiscPerhaps the most researched and well-known “flying saucer” known to the world of Ufology is the so-called “Sport Model,” which, physicist Bob Lazar came into contact with while working at the S-4 facility in Area 51 in Nevada. These are not “models” but the real thing. The dimensions of the “Sport Model” are 16 feet tall and 52 feet, nine inches in diameter. The exterior skin of the disc is metal and coloring similar to unpolished stainless steel. The craft sits on its belly when its not energized. The entry hatch is located on the upper half of the disc with just the bottom portion of the door wrapping around the center lip of the disc. The “Sport Model” is one of nine flying discs, given to the American government in an “exchange” program in the early 1970’s. The makers of the craft and providers of the fuel, Element 115, were from the Zeta Reticuli Star System. What we exchanged for the technology is not known. A back engineering program began in 1979 of the remaining hardware and technology.
Inside the Space CraftThe interior of the disc is divided into three levels. The lower level is where the three gravity amplifiers and their wave guides are located. These are the integral components of the propulsion system that are used to amplify and focus the gravity A wave. The Reactor is located directly above the three gravity amplifiers on the center level and is, in fact, centered between them. The reactor is a closed system which uses Element 115 as its fuel. Element 115 is also the source of the gravity A wave which is amplified for space-time distortion and travel. The Center level of the disc also houses the control consoles and seats, both of which were too small and too low to the floor to be functional for adult human beings. The walls of the center level are all divided into archways. At one point in time, when the disc was energized, one of the archways became transparent and you could see the area outside of it just as if the archway was a window. When the operation of the disc was being demonstrated to Lazar, something incredible happened, of which, current technology could not produce. A form of writing, which was unlike any alphabetic, scientific, or mathematical symbols Lazar had ever seen, began to appear on the one side of the transparent archway. Lazar was never given access to the upper level of the disc. Therefore, Lazar was unable to provide any specifics as to what the porthole-like areas at the top of the disc actually were, but, most definitely, they are not portholes. The ArchwayAt a certain point when the disc was energized, a form of writing appeared on the right side of the archway directly in front of the seats. The remainder of the metallic archway face became transparent, exposing the exterior view from that angle. Note the seating pattern in the illustration above. The black area would indicate the area outside the disc which became transparent to the occupants of the seats. The blue sidebar would remain and a light horizontal bar would scroll up or down the lines of text, illuminating the pattern as illustrated. Take special note to the alternating slant of every other line. The writing were forms like these with “eyes” or subcircles within the circles and ellipses. It was not explained to Lazar how this interface was actuated, except for seeing technicians switching it on from a hole in the floor of the center level main deck ... a hole where one of the gravity amplifier heads was cut out. The ReactorThe power source is a reactor which uses Element 115 as its fuel. In this reactor Element 115 is used as a target and is bombarded with protons in a small, highly sophisticated, particle accelerator. When a proton fuses into the nucleus of an atom of Element 115, it is transmuted and becomes an atom of Element 116. Although we too can transmute elements here on earth, it is typically not done in this fashion, or at anywhere near this level of efficiency. As soon as each atom of Element 115 is transmuted into Element 116, Element 116 immediately decays and produces a radiation unlike that which we normally observe in nuclear decay. Each atom of Element 116 decays and releases two antiprotons (anti-hydrogen), a form of antimatter. Antimatter can be produced in particle accelerators here on earth, but only in minute quantities and only stored for short periods of time. The Matter Anti-Matter Reactor The flux of antimatter particles produced in the reactor are channeled down an evacuated, tuned tube (which keeps it from contacting with the matter that surrounds it) and reacted with a gaseous matter target. This Total Annihilation reaction is the most efficient and energetic nuclear reaction there is. The more familiar nuclear reactions are Fission, producing energy from the splitting of atoms as used in nuclear reactors and atomic bombs, and Fusion, the fusing or combining of atoms, typically fusing hydrogen nuclei to form helium and release even more energy. Fusion is the reaction that powers the sun and other stars and is what gives hydrogen bombs their “punch.” These two more common nuclear reactions are dwarfed by the power and efficiency of the annihilation reaction used in the alien reactor. The reaction between the gaseous matter target and the antimatter particles produces a continuous release of tremendous amounts of heat. This heat is converted directly into electricity by the use of a thermionic generator. The thermionic generator used in this reactor is so efficient, that there is no detectable waste heat produced. This is an apparent violation of one of the basic laws of thermodynamics. Similar, but not nearly as efficient or powerful, thermionic generators are used as power sources in our satellites and space probes. As amazing and efficient as all this seems, it is only secondary to the primary function of the reactor. The antiparticle flux emitted from the transmuting Element 115 is not the only energy radiated during operation. This is the point at which the gravity A wave is first produced. The gravity wave emitted by the Element 115 reaction appears on the hemisphere of the reactor, propagating up the tuned waveguide in a fashion very similar to the way microwaves behave. All of the actions and reactions inside the reactor are orchestrated perfectly like a tiny little ballet, and in this manner, the reactor provides an enormous amount of power used to amplify the gravity A wave so it can cause the requisite space-time distortion for space travel. REFERENCE: http://www.boblazar.com Return to “Government Scientist Goes Public” Web Page. HYPERLINKS: Index and Direct Hyperlinks to the Other Web Pages on this Website:
|